The versatility of Skinner Bending

With more than fifty years experience, Skinner Bending offers an unusually wide range of services in the bending and forming of tubes, pipes and sections. Versatile skills and equipment, coupled with a long-standing reputation for quality ensure that the most complex designs can be converted into reality.

Service Capabilities:
Up to 150mm (6 inch) nominal bore, whether one-off or long run, no job is too big or too small for Skinner Bending.

Bending

1. Pipe and tube
2. Structural section
3. Hollow Section
4. Angle toe out
5. Angle toe in
6. Flat on flat
7. Flat on edge

Coppersmithing

Materials

1. Stainless steel specialisation, including duplex materials
2. High nickel alloys
3. Copper and brass
4. Aluminum
5. Titanium
6. Black & Galvanised carbon steels

THE SKINNER ADVANTAGE

Accurate Dimensional Control
Hot and cold sand-filled bending to 150mm diameter allows tight radii with negligible cross-sectional deformation or collapse.

Maximum Length Without Joins
Unique bending equipment, together with sandfill facilities to six metres continuous length, ensures fewer joins and minimal material wastage.

Complex Shapes
Qualified staff working with specialised equipment can produce lyrebird expansion bends and similar small radius configurations.

Adjustable Jigs and Fixtures
Uniquely adjustable jigs and fixtures enable rapid and accurate development of templates for custom bending of three dimensional profiles.

Angle Rings and Backing Flanges
Manufactured for many years to the highest standards, a comprehensive range of angle rings and backing flanges are available exstock.